Silverado Classic 3500 4WD V8-6.6L DSL Turbo (2007)
Clutch Release Bearing: Service and Repair
Release Bearing Replacement
Removal Procedure
1. Remove the manual transmission. Refer to the following:
^
Transmission Replacement for the NVG 3500 transmission
^
Transmission Replacement for the NVG 4500 transmission
2. Remove the clutch release bearing.
^
Rotate the bearing in either direction.
^
The compression spring load will push the release bearing off the end of the clutch actuator bearing.
Installation Procedure
Important:
DO NOT use cleaners or chemicals to clean the quill and DO NOT grease the quill.
1. Using a clean dry cloth, clean the exposed area of the actuator cylinder quill.
2. Install the NEW clutch release bearing to the clutch actuator cylinder.
^
Firmly push the clutch release bearing into place.
^
The release bearing will snap over the retainer tab and will be self-retained to the actuator cylinder.
3. Install the manual transmission. Refer to the following:
^
Transmission Replacement for the NVG 3500 transmission
^
Transmission Replacement for the NVG 4500 transmission
