Silverado SS AWD V8-6.0L VIN N (2003)
7. If equipped with 4WD, install the fuel hose/pipe clip to the bracket on the transfer case.
8. Install the fuel hose/pipe clip to the bracket on the transmission.
9. Install the fuel pipe bracket to the bellhousing stud.
10. Install the fuel pipe bracket nut (2).
Tighten
Tighten the nuts to .................................10 N.m (89 lb in).
11. Lower the vehicle.
12. Remove the caps from the fuel and EVAP pipes.
13. Connect the EVAP canister purge tube (3).
14. Connect the fuel feed and return pipes (1) to the fuel rail.
15. Install the fuel fill cap.
16. Connect the negative battery cable
17. Use the following procedure in order to inspect for leaks:
17.1. Turn the ignition ON, with the engine OFF, for 2 seconds.
17.2. Turn the ignition OFF for 10 seconds.
17.3. Turn the ignition ON, with the engine OFF.
17.4. Inspect for fuel leaks.
