SSR V8-6.0L VIN H (2006)
1. A) Replace the striker top latch assembly. Refer to (B) Adjust the side rail up stop. Adjust up stop one half turn at a time. It may be necessary to
repeat the adjustment until the rattle is gone. See the illustration above for up stop location.
2.
Replace the weatherstrip if damage occurred from the hook on the striker top front latch (see procedure below).
Procedure for Correction # 2
1.
Cycle the power folding top to the open position and open the doors.
2.
Remove the push-in retainer and TORX(R) head screw that retains the weatherstrip to the header.
3.
Start at the lower pillar area and remove the weatherstrip.
4.
Clean the area with 3M General Purpose Cleaner.
5.
Install the weatherstrip into the channel. Start at the corner of the header and the pillar.
6.
Install the push pin retainer and the TORX(R) screw.
7.
Cycle the power folding top to the closed position and close the doors.
Parts Information
Warranty Information
