chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Scan Tool Does Not Communicate with Class 2 Device|Page 4393 > < Scan Tool Does Not Communicate with Class 2 Device|Page 4391
Page 3
background image

-

The electronic brake control module (EBCM)

-

The inflatable restraint sensing and diagnostic module (SDM)

-

The instrument panel cluster (IPC)

-

The memory seat module (MSM) - driver, w/AAB

-

The radio

-

The remote control door lock receiver (RCDLR)

-

The roof/door module (RDM)

4. The following DTCs may be retrieved with a history status, but are not the cause of the present condition.

-

U1300

-

U1301

-

U1305

7. A state of health DTC with a history status may be present along with a U1000 or U1255 code having a current status. This indicates that the

malfunction occurred when the ignition was ON.

8. Data link connector terminals 2 and 5 provide the connection to the class 2 serial data circuit and the signal ground circuit respectively.

11. A poor connection at the DLC terminal of the splice pack SP201 would cause this condition but will not set a DTC.
12. An open or a short in the class 2 serial data circuit between the DLC and splice pack SP201 will prevent the scan tool from communicating with

any module. This condition will not set a DTC.

Scan Tool Does Not Communicate with Class 2 Device|Page 4393 > < Scan Tool Does Not Communicate with Class 2 Device|Page 4391