SSR V8-6.0L VIN H (2006)
Antenna Control Module: Service and Repair
ANTENNA MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the windshield garnish molding.
2. Remove the bolt securing the antenna module to the vehicle.
3. Disconnect the coax cable.
4. Disconnect the connector at the windshield.
INSTALLATION PROCEDURE
1. Connect the connector at the windshield.
2. Connect the coax cable.
3. Install the bolt securing the antenna module to the vehicle.
Tighten the bolt to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the windshield garnish molding.