Suburban 1/2 Ton 4WD V8-5.3L VIN Z Flex Fuel (2006)
cycled then observe from the blower motor opening in the HVAC case to see if the foam is secure. Refer to the graphic above.
Tip
If the foam is not secure, you may apply a small amount of 3M(TM) Super 77 Spray Adhesive, or equivalent, to an acid brush and apply the adhesive to
the door and reattach the loose foam.
Install the blower motor into the HVAC case by turning the blower assembly clockwise until the retaining tab locks into place.
Connect the electrical connector to the blower motor.
Reinstall the insulator panel and two screws.
Tighten
Tighten the screws to 1.6 Nm (14 lb in).
Verify that the customer's concern has been fixed.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
