Suburban 2WD V8-5.3L (2008)
1. Position the EBCM (1) to the BPMV.
2. Push the EBCM squarely onto the BPMV.
Notice: Refer to Fastener Notice .
3. Install 4 new EBCM screws (1).
Tighten the screws in an X pattern to 3 N.m (27 lb in).
4. Connect the EBCM electrical connector.
5. If installing a new EBCM, program the EBCM. Refer to Control Module References .
6. Bleed the BPMV. Refer to Antilock Brake System Automated Bleed Procedure (Without JL4) (See: Brake Bleeding/Service and Repair)Antilock
Brake System Automated Bleed Procedure (With JL4) (See: Brake Bleeding/Service and Repair) .