Suburban 2WD V8-5.3L (2008)
Tighten the USED bolt to 330 N.m (240 lb ft).
4. Remove the USED crankshaft balancer bolt.
Important: The nose of the crankshaft should be recessed 2.4-4.48 mm (0.094-0.176 in) into the balancer bore.
5. Measure for a correctly installed balancer. If the balancer is not installed to the proper dimension, install the J 41665 and repeat the installation
procedure.
6. Install the NEW crankshaft balancer bolt (139).
1. Tighten the bolt a first pass to 50 N.m (37 lb ft).
2. Tighten the bolt a final pass to 140 degrees using J 45059 .