Suburban 2WD V8-5.3L (2008)
Timing Chain: Service and Repair
Timing Chain and Sprocket Replacement (LC9/LMG/LY2/LY5) (4.8L and 5.3L)
Tools Required
*
EN 46330 Timing Chain Tensioner Retaining Pin
*
J 8433 Puller Bar
*
J 41478 Crankshaft Front Oil Seal Installer
*
J 41558 Crankshaft Sprocket Remover
*
J 41665 Crankshaft Balancer and Sprocket Installer
*
J 41816-2 Crankshaft End Protector
*
J 42386-A Flywheel Holding Tool
*
J 45059 Angle Meter
Removal Procedure
1. Remove the oil pump. Refer to Oil Pump, Screen, and Crankshaft Oil Deflector Replacement (RPOs LC9/LMG/LY2/LY5) (See: Engine
Lubrication/Oil Pump/Service and Repair)Oil Pump, Screen, and Crankshaft Oil Deflector Replacement (RPOs LY6/L76/L92) (See: Engine
Lubrication/Oil Pump/Service and Repair) .
2. Remove the starter motor. Refer to Starter Motor Replacement .
Notice: Refer to Fastener Notice .
Important: Ensure that the teeth of the J 42386-A mesh with the teeth of the engine flywheel.
3. Install the J 42386-A (1) and bolts. Use one M10-1.5 x 120 mm and one M10-1.5 x 45 mm bolt for proper tool operation.
Tighten the J 42386-A bolts to 50 N.m (37 lb ft).