Suburban 2WD V8-5.3L (2008)
1. Install the ignition lock cylinder case (1) to the vehicle.
Notice: Refer to Fastener Notice.
2. Install the 3 ignition lock cylinder case screws (2).
Tighten the screws to 7 N.m (62 lb in).
3. Install the park lock cable into the lock cylinder housing.
4. Connect the passlock and key buzzer to the ignition lock cylinder case.
5. Install the ignition/start switch.
6. Install the inflatable restraint steering wheel module coil.
Ignition Lock Cylinder Replacement
Ignition Lock Cylinder Replacement
Removal Procedure
Caution: Refer to Restraint System Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the knee bolster.
3. Remove the steering column shroud.
4. With the key installed hold it in the START position.
5. Install an allen wrench into the hole on top of the ignition lock cylinder case.
Push down on the allen wrench to release the tab on the ignition lock cylinder inside the ignition lock cylinder case.