Suburban 2WD V8-5.3L (2008)
Ignition Switch Lock Cylinder: Removal and Replacement
Ignition Lock Cylinder Case Replacement
Ignition Lock Cylinder Case Replacement
Removal Procedure
Caution: Refer to Restraint System Service Precautions.
1. Remove the inflatable restraint steering wheel module coil.
2. Remove the ignition/start switch.
3. Disconnect the park lock cable from the ignition lock cylinder case.
4. Disconnect the passlock and key buzzer from the ignition lock cylinder case.
5. Remove the 3 ignition lock cylinder case screws (2).
6. Remove the ignition lock cylinder case (1) from the vehicle.
Installation Procedure