Suburban 2WD V8-6.0L (2007)
![background image](/chevrolet/suburban_2wd/v8-6.0l/Page-2233002.png)
8. Remove the brake booster mounting nuts.
9. Remove the brake booster.
10. Remove and discard the brake booster gasket.
Installation Procedure
1. Install the NEW brake booster gasket.
Important: An assistant may be necessary to hold the brake booster in place while installing the nuts.
2. Install the brake booster to the vehicle.
Notice: Refer to Fastener Notice.
Important: Tighten the upper right brake booster nut first.
3. Install the brake booster nuts.
Tighten the nuts to 33 N.m (24 lb ft).
4. Install the pushrod (3) and stop lamp switch (2) to the brake pedal (1).
5. Install the pushrod retaining clip (4) to the brake pedal (1).