Suburban 2WD V8-6.0L (2007)
4. If equipped with active fuel management perform the following step, using J 41712 or equivalent, remove the oil pressure sensor (706) and washer
(707).
Installation Procedure
1. Apply sealant to the threads of the NEW oil pressure sensor. Refer to Sealers, Adhesives, and Lubricants.
Notice: Refer to Fastener Notice.
2. If equipped with active fuel management perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and washer
(707).
Tighten the sensor to 35 N.m (26 lb ft).