Suburban 2WD V8-6.0L (2007)
8. Remove the caps from the fuel rail and EVAP line.
9. Connect the EVAP line (1) quick connect fitting to the chassis line.
10. Connect the fuel feed line (2) quick connect fitting to the fuel rail.
11. Install the fuel fill cap.
12. Connect the negative battery cable.
13. Use the following procedure in order to inspect for leaks:
1. Turn the ignition ON, with the engine OFF, for 2 seconds.
2. Turn the ignition OFF for 10 seconds.
3. Turn the ignition ON, with the engine OFF.
4. Inspect for fuel leaks.
14. Install the intake manifold sight shield.
Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine
EVAPORATIVE EMISSION HOSES/PIPES REPLACEMENT - ENGINE
REMOVAL PROCEDURE
IMPORTANT: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the fittings in order to avoid
possible system contamination.