Suburban 2WD V8-6.0L (2007)
5. Install the propeller shaft (5) to the front axle pinion yoke (1).
Align the reference marks made during removal.
Notice: Refer to Fastener Notice.
6. Install the yoke retainers (7) and the bolts (6).
Tighten the yoke retainer bolts to 25 N.m (18 lb ft).
7. Install the boot onto the transfer case output shaft until the boot snaps into the groove on the output shaft.
8. Using the J 43218 to crimp both clamps.
9. Install the transfer case shield, if equipped. Refer to the appropriate procedure:
^
Transfer Case Shield Replacement for the BW 4485-NR3 transfer case
^
Transfer Case Shield Replacement for the NVG 246-NP8 transfer case
10. Lower the vehicle.