Suburban 3/4 Ton 4WD V8-6.0L VIN U (2004)
Head Rest: Procedures
Head Restraint Replacement (Folding)
HEAD RESTRAINT REPLACEMENT (FOLDING)
The folding headrest cannot be replaced separately. Therefore if the folding mechanism has failed, the seat back frame needs to be replaced.
Head Restraint Retainer Replacement - Front Seat
HEAD RESTRAINT RETAINER REPLACEMENT - FRONT SEAT
REMOVAL PROCEDURE
1. Slide up the seat back trim cover in order to gain access to the rear cardboard panel fasteners.
2. Remove the panel fasteners. Pull back the panel in order to gain access to the bushings.
3. Remove the head restraint retainers from the seat back frame by squeezing the retaining tabs together at the base of the guide(s) and lifting up.
INSTALLATION PROCEDURE
1. Install the head restraint retainers by pressing into the seat back frame until the retaining tabs snap into place at the bottom of the frame opening.