Suburban 3/4 Ton 4WD V8-6.0L VIN U (2004)
9. Install the cable to the mounting bracket until the locking tabs snap into place.
Notice: Refer to Fastener Notice in Service Precautions.
10. Bolt the cable to the differential (clips).
Tighten the bolt to 25 Nm (18 ft. lbs.).
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand taking
care not to pinch or kink the cable.
11. Install the cable to the differential clip.
12. Install the park brake cable to the equalizer bar by pulling down on the cable in front of the equalizer and installing the cable to the equalizer bar.
13. Remove the safety stands.
14. Lower the vehicle.
15. Adjust the park brake cable. Refer to Park Brake Adjustment.
(With RPO Nys)
Park Brake Cable Replacement - Right Rear (with RPO NYS)
Removal Procedure
1. Release the park brake.
