Suburban 3/4 Ton 4WD V8-6.0L VIN U (2004)
6. Install the new pinion nut
7. Install the J 8614-01 onto the pinion yoke as shown.
Notice: Refer to Fastener Notice in Service Precautions.
8. Tighten the pinion nut while holding the J 8614-01.
^
Tighten the pinion nut to 370 Nm (273 ft. lbs.).
9. Install the propeller shaft to the rear axle pinion yoke.
11. Lower the vehicle.
Drive Pinion Housing and/or Seal Replacement
Drive Pinion Housing and/or Seal Replacement
^
Tools Required
-
J 44414 Pinion Seal Installer
-
J 22912-01 Split-Plate Bearing Puller
-
J 24433 Pinion Cone and Side Bearing Installer
-
J 37624 Pinion Bearing Installer
-
J 8092 Universal Driver Handle 3/4 in -- 10
-
J 8608 Rear Pinion Bearing Race Installer
-
J 8614-01 Flange/Pulley Holding Tool
Removal Procedure