Suburban 3/4 Ton 4WD V8-6.0L VIN U (2004)
Transfer Case Actuator: Service and Repair
Transfer Case - NVG 246-NP8
Transfer Case Encoder Motor Replacement
Removal Procedure
1. Remove the transfer case shield, if equipped.
2. Remove the front propeller shaft.
3. Disconnect the transfer case switch electrical connector (2).
4. Disconnect the encoder motor electrical connector (7).
5. Remove the encoder motor bolts.
6. Remove the encoder motor.
7. Remove the actuator insulator gasket.
8. If replacing the encoder motor, remove the locating pins from the old motor.
Installation Procedure