Suburban 4WD V8-5.3L (2008)
Lifter / Lash Adjuster: Service and Repair
Valve Lifter Oil Filter Replacement
Valve Lifter Oil Filter Replacement
Removal Procedure
1. Remove the intake manifold. Refer to Intake Manifold Replacement (RPOs LY2/LY6) (See: Intake Manifold/Service and Repair)Intake Manifold
Replacement (RPOs LC9/LMG/LY5/L76) (See: Intake Manifold/Service and Repair)Intake Manifold Replacement (RPO L92 - First Design) (
See: Intake Manifold/Service and Repair)Intake Manifold Replacement (RPO L92 - Second Design) (See: Intake Manifold/Service and Repair) .
2. Disconnect the engine harness electrical connector (1) from the oil pressure sensor.
3. Remove the oil pressure sensor (1) and washer (2).
4. Remove and discard the valve lifter oil filter (3).
5. Remove and discard the valve lifter oil filter O-ring seal (4).
Installation Procedure
