Tahoe 2WD V8-4.8L VIN V (2004)
Pedal Positioning Sensor: Service and Repair
BRAKE PEDAL POSITION SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the BEC cover.
2. Remove the brake pedal position sensor bolts.
3. Remove the brake pedal position sensor from the vehicle.
4. Disconnect the brake pedal position sensor electrical connector.
INSTALLATION PROCEDURE
1. Connect the brake pedal position sensor electrical connector.
2. Install the brake pedal position sensor to the vehicle.
3. Install the brake pedal position sensor bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 9 N.m (80 lb in).