Tahoe 2WD V8-4.8L VIN V (2004)
1. Clean all corrosion or contaminates from the steering knuckle bore and the hub and bearing.
2. Lubricate the steering knuckle bore with wheel bearing grease or the equivalent.
3. Install the O-ring (7) to the steering knuckle, 25/35 series.
Notice: Refer to Fastener Notice in Cautions and Notices.
4. Install the wheel speed sensor mounting bolt.
^
Tighten the bolt to 18 Nm (13 ft. lbs.).
5. Install the wheel hub and bearing and splash shield to the vehicle, 25/35 series.
6. Install the wheel hub and bearing (4) and splash shield to the 15-series steering knuckle.
7. Install the wheel hub and the 15-series bearing mounting bolts.
Install the wheel hub and bearing mounting bolts, the 25/35 series.
^
Tighten the bolts to 180 Nm (133 ft. lbs.).
8. Install the wheel speed sensor and brake hose mounting bracket bolt to the steering knuckle.
^
Tighten the brake hose clip bolt to 12 Nm (106 inch lbs.).
9. Install the rotor.
10. Install the tire and wheel.
11. Lower the vehicle.
