Tahoe 2WD V8-5.3L (2007)
6. Remove the brake pipe fittings (1) from the brake hose (2).
7. Remove the brake hose bracket mounting bolt (3) from the mounting bracket (4).
8. Remove the brake hose and bracket assembly.
Installation Procedure
1. Position the brake hose (2) to the rear axle housing mounting bracket (4).
Important:
^
The brake hose must NOT be twisted during installation.
^
Leave the brake hose bracket loose, this will ease in installation the brake pipe fittings in the brake hose.
Install the brake hose mounting bracket bolt (3).
2. Remove the plugs or caps from the brake pipes fittings that were installed during the removal process.
3. Finger tighten the brake pipe fittings (1) in the brake hose (2).
