Tahoe 2WD V8-5.3L (2007)
Stabilizer Link: Service and Repair
Rear Suspension
Stabilizer Shaft Link Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the stabilizer shaft link nut and bolt from the frame bracket.
3. Remove the stabilizer shaft link nut from the ball stud.
4. Remove the stabilizer shaft link.
Installation Procedure
1. Install the stabilizer shaft link.
Important: When tightening the lower link nut, verify that the inner jam nut bottoms out on the ball stud. To ensure that the nut does not
back away during the tightening process, hold the stud with the appropriate tool.
2. Install the stabilizer shaft link nut to the ball stud.