Tahoe 2WD V8-5.3L (2007)
Suspension Strut / Shock Absorber: Service and Repair
Rear Suspension Shock Absorber
Shock Absorber Replacement (1500 Series)
Shock Absorber Replacement (1500 Series)
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the electrical connector and air line if equipped with electronic suspension control (ESC).
3. Support the rear axle.
4. Remove the upper shock absorber nut and the bolt.
5. Remove the lower shock absorber nut and the bolt.
6. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber.
2. Install the upper shock absorber nut and bolt.
Notice: Refer to Fastener Notice.
3. Install the lower shock absorber nut and bolt.