Tahoe 2WD V8-5.3L (2007)
2. Install the inner pinion bearing cup using the J 45870, 8.6 inch axle, or the J 22306, 9.5/9.5LD inch axle (2), and the J 8092 (1).
3. Determine the selective shim thickness for the drive pinion. Refer to Pinion Depth Adjustment.
4. Install the selective shim between the inner pinion bearing and the shoulder on the gear.
5. Install the inner pinion bearing using the J 24433 or the J 36614.
Press the bearing on until the cone seats on the pinion shim.
6. Install a new collapsible spacer.
7. Lubricate the pinion bearings with axle lubricant. Use the proper fluid. Refer to Fluid and Lubricant Recommendations.
8. Install the outer pinion bearing into the axle housing.
9. Install a new pinion oil seal using the J 22388.
10. Install the pinion into the axle housing.
11. Apply sealant, GM P/N 12346004 (Canadian P/N 10953480) or equivalent, to the splines of the pinion yoke.
