Tahoe 2WD V8-6.0L Hybrid (2008)
5. Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
6. Lower the vehicle.
7. Install the engine mount to frame bolts (1).
Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.
8. Install the generator bracket. Refer to Generator Bracket Replacement .
9. If the vehicle is equipped with 4WD, install the front drive axle. Refer to Differential Carrier Assembly Replacement (8.25 inch) Differential
Carrier Assembly Replacement (9.25 inch) .
10. Lower the vehicle.
11. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
Engine Mount Replacement - Right
Engine Mount Replacement - Right Side
Removal Procedure
Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the
small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will
result in a damaged oil pickup unit.
