Tahoe 2WD V8-6.0L Hybrid (2008)
Caution: Always remove and install the High Voltage terminal fasteners with a magnet tipped socket. Never touch the exposed electronic
circuit board surface or components. Dropped fasteners or physical contact may result in electronic circuit board damage.
15. Install the HV dc APM terminal fasteners (1) utilizing a magnetic socket.
Tighten the terminal fasteners to 9 N.m (80 lb in).
16. Install a new PIM cover seal (3).
17. Position the PIM cover (2) onto the PIM ensuring the seal remains in place.
18. Install the PIM cover fasteners (1).
Tighten the fasteners to 4.7 N.m (41.6 lb in).
Accessory DC Power Control Module Removal and Installation
Accessory DC Power Control Module Removal and Installation
