Tahoe 2WD V8-6.0L Hybrid (2008)
23. Remove the ball studs (1) from the drive motor generator control module.
24. Attach a lifting device (2 and 3) to the drive motor generator control module assembly at the three identified locations.
25. Lift the drive motor generator control module assembly from the vehicle.
Installation
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
1. Attach a lifting device (2 and 3) to the drive motor generator control module assembly at the three identified locations.
2. Lift the drive motor generator control module assembly into the vehicle.
3. Remove the lifting device and install the ball studs (1).