Tahoe 2WD V8-6.0L Hybrid (2008)
2. Connect the electrical connectors to their corresponding injectors.
3. Push the CPA retainer in 1 click.
4. Ensure that the connector is secured.
32. Install the engine wiring harness clip (4) to the ignition coil bracket stud.
33. Connect the engine wiring harness electrical connector (1) to the MAP sensor (4).
34. Connect the engine wiring harness electrical connector (2) to the EVAP purge solenoid (3).
35. Install the engine wiring harness bracket nut (1).
Tighten the nut to 5 N.m (44 lb in).
36. Connect the negative battery cable.
37. Use the following procedure in order to inspect for leaks:
1. Turn the ignition ON, with the engine OFF for 2 seconds.
