Tahoe 2WD V8-6.0L Hybrid (2008)
1. Lubricate the NEW fuel rail crossover pipe O-ring seals with clean engine oil.
2. Install NEW fuel rail crossover pipe O-ring seals (4) onto the crossover pipe.
3. Install the fuel rail crossover pipe (1) into the fuel rails.
4. Install the fuel rail crossover pipe retainers (3).
Notice: Refer to Fastener Notice.
5. Install the fuel rail crossover pipe retainer screws (2).
Tighten the screws to 3.8 N.m (34 lb in).
6. Gather the branches of the engine wiring harness and position over the top of the engine.
7. Position the engine wiring harness clip to the generator bracket and install the clip bolt (4).
Tighten the bolt to 9 N.m (80 lb in).
