Tahoe 4WD V8-6.0L Hybrid (2008)
5. Use a open end wrench to hold the caliper guide pin while tightening the guide pin bolt.
Tighten the bolt to 38 N.m (28 lb ft)
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
7. Lower the vehicle.
8. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
9. Slowly release the brake pedal.
10. Wait 15 seconds, then repeat steps 8-9 until a firm pedal is obtained, to properly seat the brake caliper pistons and brake pads.
11. Fill the brake master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling (See: Hydraulic
System/Brake Master Cylinder/Service and Repair/Procedures/Master Cylinder Reservoir Filling) .
12. Burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing (See: Brake Pad and Rotor Burnishing) .
