Tahoe 4WD V8-6.0L Hybrid (2008)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module Replacement (J92)
Electronic Brake Control Module Replacement (J92)
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution .
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .
Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to
observe this precaution could result in damage to the EBCM/EBTCM.
1. Place the ignition switch in the OFF position.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the antilock brake system (ABS) module splash shield retainers (1).