Tahoe 4WD V8-6.0L Hybrid (2008)
Engine Mount: Service and Repair
Engine Mount Replacement - Left Side (1500 LC9/LMG/LY5/L76/L92)
Engine Mount Replacement - Left Side (1500 w/RPOs LC9/LMG/LY5/L76/L92) (5.3L, 6.0L and 6.2L)
Removal Procedure
Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the
small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will
result in a damaged oil pickup unit.
1. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
2. If the vehicle is equipped with four wheel drive (4WD), remove the front drive axle. Refer to Differential Carrier Assembly Replacement (8.25
inch) Differential Carrier Assembly Replacement (9.25 inch) .
3. Lower the vehicle.
4. Remove the generator bracket. Refer to Generator Bracket Replacement .
5. Remove the engine mount to frame bolts (1).
6. Raise and support the vehicle halfway. Refer to Lifting and Jacking the Vehicle .
7. Remove the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
