Tahoe 4WD V8-6.0L Hybrid (2008)
5. Install the engine mount to frame bolts (1).
Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.
6. Install the A/C compressor bracket. Refer to Compressor Mounting Bracket Replacement (Non HP2) Compressor Mounting Bracket Replacement
(HP2) .
7. If the vehicle is equipped with 4WD, Install the front drive axle bracket and bolts.
Tighten the bolts to 90 N.m (67 lb ft).
8. If the vehicle is equipped with 4WD, Install the front drive axle. Refer to Differential Carrier Assembly Replacement (8.25 inch) Differential
Carrier Assembly Replacement (9.25 inch) .
9. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (See: Exhaust System/Exhaust Manifold/Service and
Repair/Exhaust Manifold Replacement - Right Side) .
Engine Mount Replacement - Right Side (2500 LY6)
Engine Mount Replacement - Right Side (2500 w/RPO LY6) (6.0L)
Removal Procedure
Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the
small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will
result in a damaged oil pickup unit.
