Tahoe 4WD V8-6.0L Hybrid (2008)
18. Position the CMP sensor.
19. Connect the engine harness electrical connector (2) to the CMP sensor wire harness electrical connector.
20. Connect the camshaft position sensor wire harness electrical connector (1) to the CMP actuator magnet.
21. Install a NEW crankshaft front oil seal. Refer to Crankshaft Front Oil Seal Replacement (RPOs LC9/LMG/LY2/LY5) Crankshaft Front Oil Seal
Replacement (RPOs LY6/L76/L92) (See: Seals and Gaskets/Front Crankshaft Seal/Service and Repair) .
22. Install the water pump. Refer to Water Pump Replacement (RPOs LY2/LC9/LY5/LMG/LFA) (See: Water Pump/Service and Repair)Water Pump
Replacement (RPOs LY6/L76/L92) (See: Water Pump/Service and Repair) .
