Tahoe 4WD V8-6.0L Hybrid (2008)
12. If replacing the exhaust manifold, remove the exhaust manifold heat shield bolts, and shield from the exhaust manifold.
Installation Procedure
Important:
*
Tighten the exhaust manifold bolts as specified in the service procedure. Improperly installed and/or leaking exhaust manifold gaskets
may affect vehicle emissions and/or On-Board Diagnostics (OBD) II system performance.
*
The cylinder head exhaust manifold bolt hole threads must be clean and free of debris or threadlocking material.
*
Do not apply sealant to the first 3 threads of the bolt.
Notice: Refer to Fastener Notice .
1. If the exhaust manifold was replaced, position and install the exhaust manifold heat shield, and bolts to the exhaust manifold.
Tighten the bolts to 9 N.m (80 lb in).