Tahoe 4WD V8-6.0L Hybrid (2008)
7. Disconnect the engine wiring harness electrical connector (3) from the right rear HO2S electrical connector.
8. Remove the right rear HO2S electrical connector clip from the engine harness clip (5).
9. Remove the left rear CPA retainer (1).
10. Disconnect the left rear HO2S electrical connector from the engine wiring harness electrical connector (3).
11. Remove the catalytic converter to exhaust manifold nuts (1).
12. Separate the catalytic converter assembly from the exhaust manifolds.
13. Lower the catalytic converter assembly using the adjustable jack.
14. Remove the exhaust seal (2 or 3) as required.
Installation Procedure
