Tahoe 4WD V8-6.0L Hybrid (2008)
Important:
The bolt is an integra part of the sensor and should remain with the sensor
4.
Disconnect the electrical connector from the high voltage circuit impact detection sensor.
4.1.
Loosen the sensor bolt.
4.2.
Remove the sensor from the vehicle.
5.
Install a new high voltage circuit impact detection sensor and bolt.
5.1.
Tighten the sensor bolt to 10 N.m (89 lb in).
5.2.
Install the electrical connector to the high voltage circuit impact detection sensor.
6.
Install the engine shield to the vehicle. Tighten the four bolts to 20 Nm (15 lb ft).
7.
Lower the vehicle.
Claim Information
For vehicles repaired under this service update, use the table.
Disclaimer