Tahoe 4WD V8-6.0L Hybrid (2008)
1. Install the lower control arm (4).
2. Install the lower control arm bolts (3).
3. Install the washers (2).
Notice: Refer to Fastener Notice .
4. Install the lower control arm retaining nuts (1).
Tighten nuts to 175 N.m (129 lb ft).
5. Install the torsion bars. Refer to Torsion Bar and Support Assembly Replacement (Bushing Style) (See: Torsion Bar/Service and Repair/Torsion
Bar and Support Assembly Replacement (Bushing Style))Torsion Bar and Support Assembly Replacement (Link Style) (See: Torsion Bar/Service
and Repair/Torsion Bar and Support Assembly Replacement (Link Style)) .
6. Install the lower ball joint into the steering knuckle.
7. Install the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (2500) (See: Transmission and Drivetrain/Drive Axles, Bearings and
Joints/Axle Shaft Assembly/Service and Repair)Wheel Drive Shaft Replacement (1500) () .
8. Install the lower ball joint retaining nut.
Tighten nuts to 110 N.m (81 lb ft).
9. Install the shock absorber. Refer to Shock Absorber Replacement (2500 Series) (See: Suspension Strut / Shock Absorber/Service and
Repair/Front Suspension Shock Absorber/Shock Absorber Replacement (2500 Series)) .
10. Remove the support for the knuckle and upper control arm.
11. Install the stabilizer shaft link to the lower control arm. Refer to Stabilizer Shaft Replacement (2500) (See: Stabilizer Bar/Service and
Repair/Front Suspension)Stabilizer Shaft Replacement (1500) () .
12. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
13. Remove the supports and lower the vehicle.