Tahoe 4WD V8-6.0L Hybrid (2008)
Back Window Glass: All Technical Service Bulletins
Body - Hybrid Decal Removal Procedures
INFORMATION
Bulletin No.: 08-08-111-001G
Date: January 22, 2009
Subject:
Decal Removal on Front and Rear Windshield on Hybrid Vehicles
Models:
2009 Cadillac Escalade Hybrid Built Prior to November 1, 2008
2008-2009 Chevrolet Malibu Hybrid, Tahoe Hybrid Built Prior to November 1, 2008
2008-2009 GMC Yukon Hybrid Built Prior to November 1, 2008
2008-2009 Saturn AURA Hybrid, VUE Hybrid
Supercede:
This bulletin is being revised to add build date information. Please discard Corporate Bulletin Number 08-08-111-001F (Section 08 - Body and
Accessories).
The purpose of this bulletin is to address the removal of hybrid decals in states that have a restriction on the usage of graphics on the front and rear glass.
Additionally, some customers may want all the hybrid vinyl graphics (front/rear glass and door graphics) removed from the vehicle. You may use this
bulletin to fulfill the customer's request in any state/province at no cost to the customer.
Removal Procedure
1.
Heat the decal using a heat gun J 25070 152 mm (6 in) from the surface.
2.
Apply the heat using a circular motion for about 30 seconds.
Notice:
Always use a plastic, flat-bladed tool to prevent surface damage when removing a decal, emblem or name plate.
3.
Remove the emblem from the surface using a plastic, flat-bladed tool.
4.
Remove all adhesive from the surface using 3M Scotch Brite molding adhesive remover disk, 3M P/N 07501, or equivalent.
5.
Clean the surface using 3M General Purpose Adhesive Cleaner P/N 08984, or equivalent.
Warranty Information
Disclaimer
