Tahoe 4WD V8-6.2L (2009)
Engine Mount: Service and Repair
Engine Mount Replacement - Right
Engine Mount Replacement - Right Side (1500 Except RPOs LY2 and LY6)
Removal Procedure
Caution: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the
small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will
result in a damaged oil pickup unit.
1. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement (See: Tune-up and Engine Performance Checks/Air
Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair).
2. If the vehicle is equipped with four wheel drive (4WD), remove the front drive axle. Refer to Differential Carrier Assembly Replacement (8.25
inch) (See: Transmission and Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Front Drive Axle/Differential
Carrier Assembly Replacement (8.25 inch))Differential Carrier Assembly Replacement (9.25 inch) (See: Transmission and
Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Front Drive Axle/Differential Carrier Assembly Replacement
(9.25 inch)).
3. If the vehicle is equipped with 4WD, remove the front drive axle bracket bolts and bracket.
4. Remove the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (See: Exhaust System/Exhaust Manifold/Service and
Repair/Exhaust Manifold Replacement - Right Side).
5. Remove the air conditioning (A/C) compressor bracket. Refer to Air Conditioning Compressor Bracket Replacement (Non-HP2) (See: Heating
and Air Conditioning/Compressor HVAC/Service and Repair).
6. Remove the engine mount to frame bolts (1).
