Tracker 2WD L4-1.6L VIN 6 (2000)
Rear Bumper Cover / Fascia: Service and Repair
Rear Bumper Fascia Replacement
Removal Procedure
1. Remove the 2 plastic retainers (2) which secure each side of the rear bumper fascia (1) in the wheelhousing area.
2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the screw which secures each side of the bottom of the rear bumper fascia (1).
4. Remove the 2 bolts (2) which secure the center bottom of the rear bumper fascia (1).
5. Lower the vehicle.
6. Open the endgate or rear door.
7. Remove the 4 plastic retainers (1) which secure the rear bumper fascia (2) along the top.
