Tracker 2WD L4-1.6L VIN 6 (2000)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor Ring Replacement
Front
Removal Procedure
1. Remove the Front Wheel Hub. Refer to Wheel Hub Bearing, and Seal Replacement.
2. Remove the ABS reluctor ring (1) from the wheel hub (2) by prying the
Installation Procedure
^
Tools Required
-
J 39245 ABS Sensor Ring Installer ring away from the hub.
1. Using J 39245, press the ABS reluctor ring (2) onto the wheel hub.
2. Install the Front Wheel Hub. Refer to Wheel Hub Bearing, and Seal Replacement.
3. Perform A Diagnostic System Check - ABS. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check
Rear
Removal Procedure