Tracker 2WD L4-1.6L VIN 6 (2000)
^
The new primary piston cup
5. Install the new piston stopper.
6. Install the piston guide and the O-rings.
7. Install the plate.
8. Depress and install the snap ring (1).
Notice: Refer to Fastener Notice in Service Precautions.
9. With the pistons pushed entirely inside the cylinder, install the piston stopper bolt.
^
Tighten the stopper bolt to 10 Nm (88.5 inch lbs.).
10. Install the master cylinder to the brake booster. Refer to Master Cylinder Replacement (Non-ABS) or Master Cylinder Replacement (ABS).
11. Apply a thin coat of brake fluid around the new grommets (4), and install the new grommets to the master cylinder (5).
12. Install the reservoir. Refer to Master Cylinder Reservoir Replacement (1.6L Non-ABS) or Master Cylinder Reservoir Replacement (1.6L
ABS/2.0L ABS/2.0L Non-ABS).
ABS
Disassembly Procedure
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Caution: Refer to Brake Fluid Caution in Service Precautions.
Notice: Refer to Filling the Master Cylinder Notice in Service Precautions.
Notice: Refer to Honing The Master Cylinder Bore Notice in Service Precautions.
Notice: Refer to Master Cylinder Body Notice in Service Precautions.
