Tracker 2WD L4-1.6L VIN 6 (2000)
Non-ABS) or Master Cylinder Description (2.0L Non-ABS) or Master Cylinder Description (ABS). Replace parts if necessary.
Important: DO NOT reuse piston cups.
13. Wash disassembled parts with brake fluid.
14. Inspect the master cylinder bore for scoring or corrosion (pits or excessive roughness). Replace a corroded master cylinder.
Important: Do NOT use a cloth in order to dry the cylinder, because lint from a cloth will stick to the cylinder bore surfaces.
15. Rinse the cylinder in clean brake fluid. Shake excess rinsing fluid from the cylinder.
Assembly Procedure
1. Install the O-ring to the master cylinder (2).
2. Install the following to the master cylinder:
^
The new piston cup
^
The secondary piston assembly
^
The new secondary piston pressure cup
3. Install the primary piston assembly to the master cylinder.
4. Install the plate.
5. Install the cylinder cup.
6. Install the piston stopper.
7. Depress and install the piston stopper snap ring into the master cylinder (2).
8. Install the master cylinder to the brake booster. Refer to Master Cylinder Replacement (Non-ABS) or Master Cylinder Replacement (ABS).
