Tracker 2WD L4-1.6L VIN 6 (2000)
Heater Core: Service and Repair
Heater Case/Cover Replacement
Removal Procedure
1. Drain the engine cooling system. Refer to Draining and Filling Cooling System in Cooling System.
2. Remove the Instrument Panel (IP) carrier.
3. Remove the heater hoses and clamps from the heater core.
4. Disconnect the electrical connector from the A/C compressor control module (2), if equipped.
5. Remove the A/C compressor control module (2), if equipped.
6. Remove the 2 nuts and 6 screws (3) from the air box.
7. Remove the air box from the vehicle. If equipped with A/C, remove the evaporator. Refer to Evaporator Core Replacement. See: Heating and Air
Conditioning/Evaporator Core/Service and Repair
8. If necessary to remove the blower case, perform the following:
8.1. Disconnect the blower motor electrical connector.
8.2. Disconnect the blower motor resistor electrical connector.
