Tracker 2WD L4-1.6L VIN 6 (2000)
Notice: Refer to Fastener Notice in Service Precautions.
3. After applying the engine oil to the housing bolts, tighten in the sequence shown.
^
Tighten the camshaft housing bolts to 10 Nm (89 inch lbs.).
4. After applying engine oil to the oil seal lip (1), install the camshaft oil seal (1) to the housing until the oil seal is flush with the surface of the
housing.
5. Install the timing belt inner cover.
6. Install the camshaft timing sprocket (1).
Important: When installing the camshaft timing sprocket to the camshaft, verify that the pin on the camshaft fits the slot marked "E" on the sprocket.
