Tracker 2WD L4-1.6L VIN 6 (2000)
7. Install the six rocker arm shaft bolts (1) into the cylinder head.
^
Tighten the rocker arm shaft bolts to 10 Nm (89 inch lbs.).
8. Fill the rocker arm shaft bolt holes with clean engine oil.
9. Install all of the intake rocker arms with the clips onto the rocker arm shaft (2).
10. Install the camshaft to the engine. Refer to Camshaft Replacement.
11. Install the timing belt to the engine. Refer to Timing Belt Replacement.
12. Install the crankshaft pulley to the engine. Refer to Crankshaft Pulley Replacement.
13. Install the radiator into the radiator core support. Refer to Radiator Replacement.
14. Install the hood latch to the front end panel.
Secure the hood latch with two bolts.
^
Tighten the hood latch bolts to 10 Nm (89 inch lbs.).
15. Connect the negative battery cable.
^
Tighten the battery cable to 15 Nm (11 ft. lbs.).
