Tracker 2WD L4-1.6L VIN 6 (2000)
Valve Cover: Service and Repair
Removal Procedure
1. Remove the two crankcase vent hoses from the valve rocker arm cover.
2. Remove the two ignition coils (4) and the secondary spark plug wires from the valve rocker arm cover.
3. Unclip the accelerator cable from the accelerator cable bracket.
4. Remove the six bolts and the valve rocker arm cover from the cylinder head.
5. Remove the valve rocker arm cover gasket and four O-rings from the cylinder head.
6. Clean the sealing surfaces on the cylinder head and the valve rocker arm cover.
Installation Procedure
Important: A new valve rocker arm cover gasket and O-rings MUST be used whenever the valve rocker arm cover removal and installation is
performed. Ensure that the new gasket and O-rings are correctly positioned during the valve rocker arm cover installation.
